Installation In Guided Mode - Fujitsu PRIMERGY RX300 S2 User Manual

3.5.2 Installation in Guided Mode

Edit the configuration file and perform installation in guided mode.
1
Turn on the server and insert the ServerStart CD-ROM immediately.
ServerStart starts up and a message appears prompting you to insert the ServerStart floppy disk.
2
Insert the ServerStart floppy disk copied in the preparatory procedure into the
floppy disk drive and click [Create].
The network setting window for remote installation appears.
3
Click [OK].
The [Initialization of ServerStart core running] window appears and unattended installation will
be started. Depending on the hardware configuration, this process may take a few minutes. When
the process is completed, the [Create a ServerStart Floppy Disk] window appears.
4
Click [or Insert a ServerStart Floppy Disk to Start ServerStart].
The [Welcome to ServerStart] window appears.
5
Click [Click here to prepare and/or initiate an operating system installation].
The [Prepare the installation of an operating system for PRIMERGY Servers] window appears.
6
Click [MS Windows Operating Systems].
The [Microsoft Windows Operating System Installation] window appears.
7
Click the OS to install.
8
Click [Prepare & initiate an unattended installation of (OS)].
The guided mode starts.
9
Click [Start have to create a complete Configuration File].
The [Open ServerStart Configuration File] window appears.
10
Specify "SerStartBatch.ini" on drive A and click [Create].
The display returns to the guided mode window.
For procedures from setting wizards to completion of installation, refer to "3.1 Guided mode"
( pg.56).
When performing remote installation, refer to "3.4 Remote Installation" ( pg.87).
PRIMERGY RX300 S2 User's Guide
3
107