Fujitsu PRIMERGY RX300 S2 User Manual page 192

Chapter 7 Installing Internal Options
●
When Installed as Standard
Installable expansion card (Model name)
Parallel Port (PG-PP03)
Remote Service Board (PG-RSB103L)
SCSI Ctrl U160 lp (PG-130L)
Fibre Channel Controller (PG-FC106)
Eth. Ctrl 1000-BASE-T Cu lp (PG-1892L)
Eth. Ctrl 1000-BASE-SX Fibre LC lp (PG-1882L)
-: Not installable.
●
With Basic Card Slot Conversion Kit
table: Expansion card installation positions and order (With Basic Card Slot Conversion Kit)
Installable expansion card (Model name)
RAID Ctrl 2-Channel 128MB w/ BBU (PG-142E3)
Remote Service Board (PG-RSB103)
SCSI Ctrl U160 (PG-128)
Fibre Channel Controller (PG-FC106)
Eth. Ctrl 1000-BASE-T Cu (PG-1892)
Eth. Ctrl 1000-BASE-SX Fibre LC (PG-1882)
Eth. Ctrl 1000-BASE-T Cu (PG-1852)
Eth. Ctrl 2 x 1000-BASE-T Cu (PG-1862) *1
*1: The PG-1862 cannot be installed together with other LAN cards.
■ Notes on Installing Expansion Cards
●
Driver
For expansion card drivers, refer to "2.3.5 Expansion Cards Supported by ServerStart" ( pg.50).
●
Notes on Each Card
For notes of specific expansion card, refer to the manuals supplied with the card and the notes provided
with the server. Also, check the following for respective expansion cards.
●
SCSI Card/RAID Card
• Connection of a SCSI device
Connect a SCSI device supported by this server to the SCSI or RAID card. Operations of
unsupported SCSI devices are not guaranteed.
192
table: Expansion card installation positions and order (Standard)
PCI slot
1 2 3 4
- - - -
- - 1 -
1 2 3 4
3 4 5 1
3 4 5 1
3 4 5 1
PCI slot
Installati
on order
6 7 8
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
1 2 3
Installatio
n order
5
1 1
- 2
5 3
2 4
2 5
2 6
1
2
3
4
5
6
7
8