Installing An Internal Hard Disk Unit - Fujitsu PRIMERGY BX620 S4 User Manual

7.7 Installing an Internal Hard Disk
Unit
This section explains how to install internal hard disk units.
• When installing or removing the units, make sure to remove the Server Blade
from the Chassis. Failure to do so may cause electric shock.
For details on how to remove the Server Blade from the Chassis, refer to
"BX600 S3 Blade Server System Unit Hardware Guide".
In the array system configuration (RAID1), you can replace the internal hard
disk unit without turning the power off.
• Rough handling of the hard disk unit can damage the stored data. To cope with
any unexpected problems, always back up important data. When backing up
data to another hard disk unit, you should make backups on a file or block
basis.
• Use the unit in a dry place with low airborne dust levels.
• Use the device on a shock-and-vibration free surface.
• Keep the device away from direct sunlight, radiators or other heat sources.
• Do not use the unit in a place where the temperature is extremely high or low,
or experiences extreme temperature changes.
• Do not disassemble the hard disk unit.
• Take great care so that you do not hit the hard disk or bring it into contact with
metallic objects.
• The circuit boards and soldered parts of internal options are exposed. They
can be damaged by static electricity. Before handling them, first touch a metal
part of the Chassis to discharge static electricity.
• Do not touch the circuitry on boards or soldered parts. Hold the metallic areas
or the edges of the circuit boards.
PRIMERGY BX620 S4 Server Blade User's Guide
197