High Power DC Electronic Load 63200 Series Operation & Programming Manual
Then the display will go to the first editing page again.
4.2.2 Setting the Program
The Electronic Load is able to select customized basic tests, and link them to a program test
for automatic execution.
The
key is used to select program or recall program for local control. There are ten
PROG.
programs (1-10). Each program has ten sequences to map files from 1 to 100. Program 1
maps files from 1 to 10. Table 4-1 shows the relationship between the program sequence
and the corresponding file.
Program 1 Sequence No.
Corresponding File No.
Program 2 Sequence No.
Corresponding File No.
:
:
Program 10 Sequence No.
Corresponding File No.
Table 4-1 The Relationship of the Program Sequence and the Corresponding File.
When running a program you must set its corresponding file parameters first. If one
program sequence is not enough for you to test the UUT, you can use program chain function
to get more sequences.
Press
key, and the LCD will display as follows. Press number 1 -10 followed by
PROG.
to recall program from EEPROM, or use ▲, ▼ keys to edit the program.
ENTER
1.
Setting the Program Chain
The chain function of program enables you to chain program so as to get more sequences
for testing. Set program chain number to 0 means no program chained. Program
chain function can chain itself for loop test, or other programs.
Press
,
1
ENTER
4-10
1
2
1
2
1
2
11
12
1
2
91
92
PROGRAM SELECT
No:
1
to chain itself for loop test. The default setting is 0.
PROGRAM
No:
1
3
4
5
6
3
4
5
6
3
4
5
6
13
14
15
16
3
4
5
6
93
94
95
96
CHAIN
7
8
9
10
7
8
9
10
7
8
9
10
17
18
19
20
7
8
9
10
97
98
99
100