Chroma 63200 Series Operation & Programming Manual page 7

SAFETY SUMMARY
The following general safety precautions must be observed during all phases of operation,
service, and repair of this instrument. Failure to comply with these precautions or specific
WARNINGS given elsewhere in this manual will violate safety standards of design,
manufacture, and intended use of the instrument. Chroma assumes no liability for the
customer's failure to comply with these requirements.
BEFORE APPLYING POWER
Verify that the product is set to match the available line voltage and the correct fuse is
installed.
PROTECTIVE GROUNDING
Make sure to connect the protective grounding to prevent an electric shock before turning on
the power.
NECESSITY OF PROTECTIVE GROUNDING
Never cut off the internal or external protective grounding wire, or disconnect the wiring of
protective grounding terminal. Doing so will cause a potential shock hazard that may bring
injury to a person.
FUSES
Only fuses with the required rated current, voltage, and specified type (normal blow, time
delay, etc.) should be used. Do not use repaired fuses or short-circuited fuse holders. To
do so could cause a shock or fire hazard. Caution: Be sure to remove the power cord before
changing the fuses.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of flammable gases or fumes.
DO NOT REMOVE THE COVER OF THE INSTRUMENT
Operating personnel must not remove the cover of the instrument. Component replacement
and internal adjustment can be done only by qualified service personnel.
CLEANING THE INSTRUMENT
Please use a clean and dry cloth to clean the instrument surface.
v