Query Syntax CONFigure:VOLTage:LATCh?
Return Parameters 0 | 1
Query Example CONF:VOLT:LAT?
Return Example 0 (OFF)
CONFigure:VOLTage:LATCh:RESet
Description Reset Von signal.
Syntax CONFigure:VOLTage:LATCh:RESet
Parameters None
Example CONF:VOLT:LATC:RES
CONFigure:VOLTage:ON
Description Set the voltage of sink current to on.
Syntax CONFigure:VOLTage:ON <NRf> [suffix]
Parameters For valid voltage range refer to respective specification.
Example CONF:VOLT:ON 1
Query Syntax CONFigure:VOLTage:ON?
Return Parameters <NR2> [Unit=Voltage]
Query Example CONF:VOLT:ON?
Return Example 3.5
CONFigure:VOLTage:POLarity
Description Set the voltage display polarity.
Syntax CONFigure:POLarity <NR1 | CHAR>
Parameters 0 | MINUS, 1 | PLUS,
Example CONF:POL 0
Query Syntax CONFigure:POLarity?
Return Parameters 0 | 1
Query Example CONF:POL?
Return Example 0 ( MINUS )
CONFigure:VOLTage:RANGe
Description Set voltage measurement range in CC mode.
Syntax CONFigure:VOLTage:RANGEe <NR1 | CHAR>
Parameters 0 | L, 1 | H
Example CONF:VOLT:RANG 1
Query Syntax CONFigure:VOLTage:RANGe?
Return Parameters 0 | 1
Query Example CONF:VOLT:RANG?
Return Example 1 ( H )
CONF:VOLT:LAT OFF
CONF:VOLT:ON 300mV
CONF:POL PLUS
CONF:VOLT:RANG L
Language Dictionary
Set the action type toVon as Non Latch
(Refer to the former part of this
manual for detailed).
Return the action type to Von.
Set Von=1V.
Set Von=300mV.
Return the setting of Von value.
Set voltage display to minus.
Set voltage display to plus.
Return the display polarity.
Set full-range to High.
Set full-range to Low.
Return Voltage range.
7-7