Chroma 63200 Series Operation & Programming Manual page 85

Return Example Chroma,63203,12345678,01.00
*OPC
Description This command causes the interface to set the OPC bit (bit 0) of the
Syntax *OPC
Parameters None
*OPC?
Description This query returns an ASCII "1" when all pending operations are
Query Syntax *OPC?
Return Parameters <NR1>
Query Example 1
*RCL
Description This command restores the electronic load to a state that was
Syntax *RCL <NRf>
Parameters 1 to 100
Example *RCL 50
*RST
Description This command forces an ABORt, *CLS, LOAD:PROT:CLE
Syntax *RST
Parameters None
*SAV
Description This command stores the present state of electronic load in a
Syntax *SAV <NRf>
Parameters 1 to 100
Example *SAV 50
*SRE
Description This command sets the condition of the Service Request Enable
Syntax *SRE <NRf>
Operation Complete Command
Standard Event Status register when the Electronic Frame (6320) has
completed all pending operations.
Operation Complete Query
completed.
Recall Instrument State Command
previously stored in memory with *SAV command to the
specified location (see *SAV).
Reset Command
command.
Save Command
specified location in memory.
Service Request Enable Command/Query
register to determine which event of the Status Byte register (see
*STB) is allowed to set the MSS (Master Status Summary) bit. A
"1" in the bit position enabled by bits is logically ORed to cause Bit
6 (the Master Summary Status Bit) of the Status Byte register to be
set. See details regarding the Status Byte register in Chapter 8
Status Reporting.
Language Dictionary
7-3