Maintenance Mode; Setup Menu - Sony Betacam SX DNV-5 Maintenance Manual

2-1. Setup Menu

This unit has the SETUP menu required for the settings and adjustments of the camera.
This section describes the SVC (SERVICE) mode.
Data structure
The menu has the following data structure.
Set value of the data (or adjust value) = fixed data (absolute value) + set value of the SVC mode (relative value) + set value
of the ENG mode (relative value) + set value of the USER mode (relative value)
. The fixed data is stored in IC74 (this IC is mounted in the IC socket (CNI1) on the DCP-1 board), and the set values of
the USER, ENG and SVC modes are stored in IC152 (on the DCP-1 board).
. The set values of the USER, ENG and SVC modes are set to 0 when the unit is shipped from the factory. Execute the
DATA RESET of each mode to return to the factory shipping data. (The adjustment is required.)
Set value of the SETUP menu
(or adjust value)
1. SVC mode
. The replacement boards for repair purpose supplied from the repair parts center is adjusted at the factory. However, due
to the variability of respective products, perform the adjustment using the SVC mode after the board replacement, or
when you require the fine-adjustment.
. When adjustment is performed using the SVC mode, the values of items adjusted in the ENG mode and the USER mode
become 0.
2. Setup card
. The set values of the USER mode and ENG mode are stored separately in the setup card.
. The set value at the factory is stored as fixed data. This value may differ for each unit. The [fixed data + set value in SVC
mode] in each state must be made the same when an identical setup card is used before and after board replacement or
between different units.
Using the reference unit it is recommended to store the set values of the USER mode and the ENG mode beforehand in
the setup card. Then replace the board or use another unit, perform adjustment using the SVC mode, and download the
stored data from the setup card.
DNV-5
DNW-7/90/90WS
http://getMANUAL.com
Section 2

Maintenance Mode

USER mode data (relative value)
ENG mode data (relative value)
SVC mode data (relative value)
Fixed data (absolute value)
2-1. Setup Menu
Save the setup card
Data at the factory
2-1