End Sensor Assembly Replacement - Sony Betacam SX DNV-5 Maintenance Manual

3-3-21. End Sensor Assembly Replacement

3-3-21. End Sensor Assembly Replacement
Outline
Replacement
End sensor assembly removal
End sensor assembly installation
Preparations
1. Confirm that the unit is in the unthreading end state.
2. Turn off the power.
3. Remove the front lid and outside panel.
(Refer to section 1-6 in Part 1 of the Maintenance Manual.)
n
The end sensor assembly can be replaced with the cassette compartment installed in
the unit.
Tools
. Torque screwdriver bit (for M1.4)
. Torque screwdriver (for 3 kg)
Removal
1. End sensor assembly removal
(1) Remove one screw securing the end sensor
assembly.
(2) Remove the end sensor assembly while
disconnecting connector CN509 on the
MDC-5 board.
Installation
2. End sensor assembly installation
(1) Connect the connector of the end sensor
assembly to connector CN509 on the MDC-5
board while aligning the two positioning pins
at the bottom of the end sensor assembly with
the positioning holes of the MD chassis.
(2) Tighten the screw for the end sensor assem-
bly.
[Tightening torque:
9 x 10 _2
N.m (0.9 kgf.cm)]
3-94
J-6325-110-A
J-6325-400-A
End sensor assembly
Screw
(P1.4 x 3.5)
Connector
CN509
MDC-5 board
Positioning
pins
Positioning
holes
DNV-5
DNW-7/90/90WS