Sony Betacam SX DNV-5 Maintenance Manual page 24

2-1. Setup Menu
Viewfinder screen (Factory default setting)
* LEVEL 9 *
H PHASE : –37 (PAL : –32)
SC PHASE : 0
SC 0/180 SELECT : 0
SC-H : 0
IRIS SET : 0
IRIS MODE : 0
IRIS WEIGHT : 0
IRIS SPEED : 0
CLIP HIGH LIGHT : OFF
* W-SHAD._G *
H SAW : 0
H PARA : 0
V SAW : 0
V PARA : 0
H SAW (EXT) : 0
H PARA (EXT) : 0
V SAW (EXT) : 0
V PARA (EXT) : 0
SHAD COMP : ON
TEST OUT : ENC
2-10
Description
........... Sets the H phase of the camera in the external genlock mode.
........... Sets the SC phase of the camera in the external genlock mode.
........... Inverts the SC phase of the camera in the external genlock mode. (Selects
either 0 or 180 degrees.)
........... Sets the INT SC phase reference level.
........... Sets the auto iris reference level.
........... Sets the auto iris control level.
........... The more this set value increase, it approaches the average. The less this set
value decreases, it approaches the peak. Monitor the level bar at the upper
right on the viewfinder screen for this setting item to check that it approaches
the peak level or average level. The "P" indication on the left of the level bar
means the peak level. The "A" indication on the right of the level bar means the
average level.
........... Sets the valid range of the auto iris. (The larger number make the valid range
narrower.)
........... Sets the auto iris response speed.
........... Limits the auto iris detection to 100% for the subject of high brightness (video
level: 100% or more)
........... Sets the manual white shading correction amount of G signal.
........... Sets the manual white shading correction amount of G signal during the
extender mode.
........... Sets whether to activate the shading correction on G signal.
........... Sets the type of the video signal output from the TEST OUT connector.
n
Same as TEST OUT item of the "FUNCTION 1/2" page.
DNV-5
DNW-7/90/90WS