Sony Betacam SX DNV-5 Maintenance Manual page 89

Installation
5. Reel drive gear assembly installation
(1) Temporarily attach a new reel drive gear
assembly with two screws.
(2) Tighten the preceding screws to required
torque while pressing the reel drive gear
assembly in the direction of the arrow.
[Tightening torque:
9x10
6. Timing belt (reel) installation
(1) Install the timing belt around the pulleys of
the reel drive gear assembly and capstan
motor.
(2) Hang the timing belt on the pin on the MDC-
5 board as shown in the figure.
Adjustment after replacement
7. Belt tension adjustment
(Refer to section 4-1-5.)
8. S soft brake assembly installation
Install the S soft brake assembly with two screws.
9. Blind panel installation
(1) Install the blind panel with eight screws.
(2) Install the four rubbers for harness clamping.
DNV-5
DNW-7/90/90WS
–2 N.m (0.9 kgf.cm)]
Pin
Pulley
(capstan motor)
Screws(M1.4 x 3.5)
MDC-5 board
Pulley
(capstan motor)
Blind panel
Pin Timing belt (reel)
3-2-8. Reel Drive Gear Assembly Replacement
Reel drive gear assembly
Pulley (reel drive gear assembly)
Timing belt (reel)
Screws
(M2 x 4.5)
Harness
clampers
Screws
(M2 x 4.5)
Harness clamper
Screw (M2 x 4.5)
Pulley (reel drive gear assembly)
3-39