Precaution During Manual Ejection - Sony Betacam SX DNV-5 Maintenance Manual

3-1-3. Threading End State/Unthreading End State

3-1-4. Precaution during Manual Ejection

2. Unthreading end state
In the unthreading end state, the S and T sliders move from catchers S and T to the
reel table and stop. This state also corresponds to the STANDBY state.
At that time, the cassette compartment is put into the up state.
(1) How to enter the unthreading end state
Press the EJECT button.
(2) How to enter the unthreading end state manually
Turn the warm wheel of the manual eject assembly. (Refer to section 3-1-4.)
n
For how to enter the unthreading end state with the cassette tape inserted, refer
to section 1-11 in Part 1 of the Maintenance Manual.
3-1-4. Precaution during Manual Ejection
Even if the power is not turned on, the unit can be put into the threading end or
unthreading end state by turning the warm wheel of the manual eject assembly or the
manual eject gear.
But the manual eject gear functions only in the unthreading direction.
The warm wheel functions in the both threading and unthreading directions.
m
. Do not turn each manual eject gear continuously more than required. If so, the
parts that constitute the unit may be damaged.
To turn the warm wheel, use a Phillips screwdriver (for M3).
Phillips screwdriver (for M3)
. The warm wheel has been installed so that it can be used by the engineer during
tape slacking.
Manual eject gear
Warm wheel
3-4
7-700-749-01
DNV-5
DNW-7/90/90WS