Sony Betacam SX DNV-5 Maintenance Manual page 110

3-3-8. Reel Table Replacement
Installation
3. Reel shaft cleaning
Clean the reel shaft with cleaning cloth moistened
with cleaning fluid.
4. Reel table cleaning
(1) Clean the surface of the reel table, which the
tension regulator band assembly touches,
with cleaning cloth moistened with cleaning
fluid.
(2) Wipe the bottom of the reel table with dry
cloth.
5. Reel table installation (1)
Pass the reel table through the reel shaft while
releasing the soft brake with fingers.
6. Reel table height adjustment
(Refer to section 4-1-1.)
7. Reel table installation (2)
(1) Pass the remaining polywasher in step 6
through the reel shaft.
(2) Install the reel table using a new stop washer.
(3) Confirm that there is a play when the reel
table is moved in the vertical direction. If
there is no play, remove one polywasher on
the reel table.
8. Tension regulator band assembly
installation (required when replacing
S reel table alone)
(1) Hook the tension regulator band assembly
removed in step 1 on the tension regulator
arm assembly.
n
Be careful not to bend and damage the
tension regulator band assembly during
installation.
(2) Install the tension regulator arm assembly
using a new stop washer while holding it by a
screwdriver.
n
Do not apply excessive force to the tension
regulator arm assembly and tension regulator
link assembly when fixing the stop washer.
3-60
Reel shafts
(cleaning)
• S/T reel table
Polywashers
Bottom surface
Contact surface
DNV-5
DNW-7/90/90WS