Sony Betacam SX DNV-5 Maintenance Manual page 27

Viewfinder screen (Factory default setting)
* OPERATION MODE 1 *
R-G/B-G SEL. : OFF
GAMMA TABLE : A (PAL : B)
LOW LIGHT : OFF
BARS SELECT : 1
WHITE B : AWB
BATT WARNING : 10%
WIDE AWB : ON
ZEBRA : OFF
* OPERATION MODE 2 *
TIME CODE DISP : OFF
* SG ADJ. *
H BLKG WIDTH : 0
V BLKG : 20 H
DNV-5
DNW-7/90/90WS
Description
........... Sets whether to add the R-G and B-G signals to the TEST OUT setting of the
setup menu.
........... Selects the characteristics of the gamma correction.
More distinct black gradation is obtained when this item is set to B.
Normally setting to A.
A : Sony standard gamma curve
B : High gain gamma curve
........... Sets the starting level of the LOW LIGHT display on viewfinder.
OFF : No display
1 : Approx. 10 %
2 : Approx. 15 %
3 : Approx. 20 %
........... Sets the type of built-in color bars signal
1 : SMPTE color bars
2 : EBU color bars (PAL)/Full color bars (NTSC)
3 : SNG color bars
........... Sets the function of white balance (B-CH)
AWB : Auto white balance
ATW : Auto tracing white balance
........... Sets the blinking (alarm) starting level of the remaining amount of battery in
ANTON BAUER Inc., battery.
10% : Starts blinking when the remaining amount of battery voltage reaches
about 0.67 V.
20% : Starts showing the 20% display when the remaining amount of battery
voltage reaches about 1.33 V, and starts blinking at about 1.0 V.
........... Widens the adjustment range of auto white balance.
........... Sets this item when a VF without the zebra switch is used.
A zebra pattern is forcibly displayed on the viewfinder screen regardless of the
VF zebra switch setting when this item is set to ON.
........... Sets whether to output the time code to the TEST OUT connector and viewfind-
er screen.
VF : Outputs the time code to the viewfinder only.
TEST : Outputs the time code to the TEST OUT connector only.
BOTH : Outputs the time code to the viewfinder and TEST OUT connector.
OFF : Outputs no time code.
........... Sets the H blanking width.
........... Selects the V blanking width. (19 H, 20 H, or 21 H) (For NTSC only)
2-1. Setup Menu
2-13