Sony Betacam SX DNV-5 Maintenance Manual page 31

Viewfinder screen (Factory default setting)
* VA ADJ.-2 *
R PREKNEE : 0
G PREKNEE : 0
B PREKNEE : 0
R PREKNEE (DCC) : 0
G PREKNEE (DCC) : 0
B PREKNEE (DCC) : 0
TEST OUT : ENC
TEST SAW : OFF
* AD ADJ. *
R AD GAIN : 0
G AD GAIN : 0
B AD GAIN : 0
AD CK PHASE : xx ns
R/B CK PHASE : xx ns
DNV-5
DNW-7/90/90WS
Description
........... Adjusts the preknee value when the OUTPUT/DCC selector is set to DCC OFF.
........... Adjusts the preknee value when the OUTPUT/DCC selector is set to DCC ON.
The knee slope obtains a fixed slope (which is the same between R, G, and B)
when the OUTPUT/DCC selector is set to DCC ON then back OFF.
Adjusts the value of preknee (DCC) to minimize carrier leak.
........... Sets the type of the video signal output from the TEST OUT connector.
n
Same as TEST OUT item of the "FUNCTION 1/2" page.
........... Sets whether to close the lens forcibly and add the TEST SAW waveform to the
video signal circuit.
n
This item is the same as the "TEST SAW" item on the "VA ADJ. 1/2" page.
........... Adjusts the gain of the video signal input to the AD converter.
n
Never attempt to change the value except when the AD and/or VA board is
replaced, because it was adjusted the factory.
........... Adjusts the Gch-clock phase of the AD converter.
n
Never attempt to change the value except when the CCD block and/or CDP-1
board is replaced, because it was adjusted the factory.
........... Adjusts the Rch- and Bch-clock phases of the AD converter.
n
Never attempt to change the value except when the CCD block and/or DCP-1
board is replaced, because it was adjusted the factory.
2-1. Setup Menu
2-17