Diag Menu - Sony Betacam SX DNV-5 Maintenance Manual

2-2. DIAG Memu

2-2. DIAG Menu

The DIAG menu is used for the maintenance menu setting and troubleshooting of the DNV-5.
m
. Use the DIAG menu in the state in which the tape transport stopped.
. Do not execute the DIAG menu when remote control RM-P9 is connected. The self-diagnosis function
and remote control function are not normally activated when the self-diagnosis is executed.
Operation
1. DIAG menu activation
Push the DIAG switch on the inside panel with the tip of a clip so as to display the DIAG menu on
the LCD display.
2. PAGE selection
Press the ADVANCE button and select the PAGE.
To increment the menu number, press the ADVANCE button.
To decrement the menu number, press the ADVANCE and HOLD buttons simultaneously.
After selection, Press the SHIFT button.
Select the PAGE repeatedly until the desired ITEM is found.
3. ITEM selection
Press the ADVANCE button and select the ITEM.
After selection, press the SHIFT button.
4. ITEM setting
Press the ADVANCE button to change the set value.
After change, press the SHIFT button.
5. DIAG menu termination
Press the DIAG switch.
2-28
DNV-5
DNW-7/90/90WS