Connecting To A Modem - Enterasys Matrix E1 1G694-13 Configuration Manual

2.1.4

Connecting to a Modem

To connect a modem to an Enterasys Networks device modem port
with RJ45 connectors and an optional RJ45-to-DB25 male adapter (PN 9372112), and proceed as
follows:
1. Connect the RJ45 connector at one end of the cable to the modem port on the Enterasys
Networks device.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 male adapter.
Refer to Section 2.1.5
3. Connect the RJ45-to-DB25 adapter to the communications port on the modem.
4. Turn on the modem and configure your VT emulation package with the following parameters:
5. When these parameters are set, the Matrix E1 startup screen will display.
for adapter wiring and signal assignments.
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Matrix E1 Series (1G694-13) Configuration Guide
Setup Requirements
Connecting to a Modem
(Figure 2-3), use a UTP cable
2-5