Structure Of This Guide; Overview; Local Management Requirements - Enterasys Matrix E1 1G694-13 Configuration Manual

Structure of This Guide

STRUCTURE OF THIS GUIDE
The guide is organized as follows:
Chapter 1, Introduction, provides an overview of the tasks that can be accomplished using the
CLI interface, an overview of local management requirements, and information about obtaining
technical support.
Chapter 2, Setup Requirements, describes how to configure and connect a management terminal
or a modem to the SmartSwitch device, and how to Telnet to the device.
Chapter 3, Startup and General
default settings and describes how to start the CLI interface, how to set basic system information,
how to set SNMP community names and traps, how to set the login password and how to exit the
CLI.
Chapter 4, Port Configuration, describes how to review port status, enable or disable ports,
enable or disable port auto-negotiation, set port flow control, set port traps and port mirroring, and
how to configure port trunking.
Chapter 5, Spanning Tree
(802.1D and 802.1w) bridge parameters for the device, including bridge priority, hello time,
maximum aging time and forward delay, and how to review and set Spanning Tree port
parameters, including port priority and path costs.
Chapter 6, 802.1Q VLAN
according to VLAN, establish VLAN forwarding (egress) lists, route frames according to VLAN
ID, and configure ports on the switch as GVRP-aware ports.
Chapter 7, Port Priority
display the current traffic class-mapping-to-priority or each port, and to set ports to transmit
frames according to selected priority transmit queues. It also describes how to configure Quality of
Service (QoS) settings.
Chapter 8, IGMP Configuration, describes how to configure Internet Group Management
Protocol (IGMP) settings for multicast filtering, including IGMP query count, IGMP report delay
and IGMP group status.
Chapter 9, Network
monitor network events and status, including the eventlog, command history, netstats and RMON
statistics, and how to manage network addresses and routes.
xvi Matrix E1 Series (1G694-13) Configuration Guide
Configuration, provides and overview of the device's factory
Configuration, describes how to review and set Spanning Tree
Configuration, describes how to create static VLANs, filter frames
Configuration, describes how set the transmit priority of each port,
Management, describes how to manage general device settings, how to