Connecting To A Modem; Connecting A Vt Series Terminal - Enterasys SecureStack C2 C2G124-48P Hardware Installation Manual

Connecting to Console Port for Local Management
Figure 3-11
1 DB9 female cable connector
2 Serial interface cable
3 DB9 male Console port connector

Connecting to a Modem

To connect a modem to an Enterasys
UTP cable terminated with a DB9 female connector and a DB25 male connector, and
proceed as follows:
1. Connect the DB9 female connector at one end of the cable to the Console port on the
Enterasys switch. (If there is a switch designated as the Manager, connect to its
Console port.)
2. Plug the DB25 male connector at the other end of the cable into the modem
communications port.
3. Turn on the modem and make sure the remote modem is ON.
4. With your PC connected to the remote modem, configure your VT emulation package
with the following parameters:
3-20 Hardware Installation

Connecting a VT Series Terminal

Ä
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Á
Ã
4 DB25 female connector
5 PC with VT emulation application
Networks switch modem port (Figure
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
À Â
3‐12), use a