3.9.4
Connecting to a Modem
To connect a modem to an Enterasys Networks device modem port
with RJ45 connectors and an optional RJ45-to-DB25 male adapter (PN 9372112), and proceed as
follows:
1. Connect the RJ45 connector at one end of the cable ➀to the RJ45 console port ➁ on the
Enterasys Networks device.
2. Plug the RJ45 connector at the other end of the cable ➀ into the RJ45-to-DB25 male adapter ➂.
3. Connect the RJ45-to-DB25 adapter ➂ to the communications port of the modem ➃.
4. At the remote site, ensure that the PC ➅ is connected to the modem ➄.
5. Turn on the modem and configure your VT emulation package with the following parameters:
When these parameters are set, the startup screen will display. Proceed to
the installation.
Figure 3-23 Connecting to a Modem
Å
UTP straight-through cable
➀
with RJ45 connectors
➁
RJ45 console port
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Ä
➂
➃
Connecting to Console Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Ã
Â
RJ45-to-DB25 modem adapter
Local modem
(Figure
3-23), use a UTP cable
Section 3.10
to complete
Á
À
➄
Remote Modem
➅
PC
Hardware Installation
3-33