Set Spantree Tctrapsuppress - Enterasys Matrix E1 1G694-13 Configuration Manual

5.2.1.14 set spantree tctrapsuppress

Use this command to disable or enable topology change trap suppression on Rapid Spanning Tree
edge ports. By default, RSTP non-edge (bridge) ports that transition to forwarding or blocking
cause the switch to issue a topology change trap. When topology change trap suppression is
enabled, which is the device default, edge ports (such as end station PCs) are prevented from
sending topology change traps. This is because there is usually no need for network management to
monitor edge port STP transition states, such as when PCs are powered on. When topology change
trap suppression is disabled, all ports, including edge and bridge ports, will transmit topology
change traps.
set spantree tctrapsuppress {disable | enable}
Syntax Description
disable | enable
Command Defaults
None.
Command Mode
Read-Write.
Example
This example shows how to allow Spanning Tree edge ports to transmit topology change traps:
Matrix>set spantree tctrapsuppression disable
Success setting topology change trap suppression to DISABLE.
Reviewing and Setting Spanning Tree Bridge Parameters
Disables or enables topology change trap suppression.
Matrix E1 Series (1G694-13) Configuration Guide
Spanning Tree Configuration
5-19