3.2.5.3
clear trap
Use this command to clear an SNMP trap assigned to an IP address.
clear trap ip_address
Syntax Description
ip_address
Command Defaults
None.
Command Mode
Read-Write
Example
This example shows how to clear the trap assigned to IP address 172.29.65.123.
Matrix>clear trap 172.29.65.123
Trap cleared.
3.2.6
Closing the CLI
Purpose
To close your CLI session.
Command
The command used to close the CLI session is listed below and described in the associated section
as shown.
• exit
(Section
3.2.6.1)
Specifies the IP address of the trap to be cleared.
Matrix E1 Series (1G694-13) Configuration Guide
Startup and General Configuration
Closing the CLI
3-33