Connecting to COM Port for Local Management
2.
Plug the RJ45 connector at the other end of the UTP straight‐through cable into the
RJ45‐to‐DB25 female adapter.
3.
Connect the RJ45‐to‐DB25 adapter to the port labeled COMM on the VT terminal.
4.
Turn on the terminal to access the Setup Directory and set the following parameters:
When these parameters are set, the Local Management password screen will display.
Refer to the Enterasys Matrix DFE‐Platinum Series Configuration Guide for further
information.
Figure 3-10
1 UTP straight-through
2 RJ45 COM port
Connecting to a Modem
To connect a modem to an Enterasys Networks DFE
a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25 male adapter,
and proceed as follows:
3-22 Installation
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Connecting a VT Series Terminal
Ã
cable with RJ45 connectors
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Â
À
3 RJ45-to-DB25 VT adapter
4 VT series terminal
module COM port (Figure
Á
3‐11), use