Connecting To A Vt Series Terminal - Enterasys Matrix E1 1G694-13 Configuration Manual

5. When these parameters are set, the Matrix E1 startup screen will display.
Figure 2-1 Connecting an IBM PC or Compatible Device
À
PC
RJ45-to-DB9 PC Adapter
2.1.3

Connecting to a VT Series Terminal

To connect a VT series terminal to an Enterasys Networks switch console port
UTP cable with RJ45 connectors and an optional RJ45-to-DB25 female adapter (PN 9372110),
and proceed as follows:
1. Connect the RJ45 connector at one end of the cable to the console port on the Enterasys
Networks device.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 female adapter.
Refer to Section 2.1.5
3. Connect the RJ45-to-DB25 adapter to the port labeled COMM on the VT terminal.
Á
UTP Cable with RJ45 Connectors
RJ45 Console Port
for adapter wiring and signal assignments.
Connecting to a VT Series Terminal
Â
Matrix E1 Series (1G694-13) Configuration Guide
Setup Requirements
PWR CPU
Reset
Console
Ã
(Figure 2-2), use a
2-3