3.9.4
Connecting to a Modem
To connect a modem to an Enterasys Networks device modem port
with RJ45 connectors and an optional RJ45-to-DB25 male adapter (PN 9372112), and proceed as
follows:
1. Connect the RJ45 connector at one end of the cable to the modem port on the
Enterasys Networks device.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB25 male adapter.
3. Connect the RJ45-to-DB25 adapter to the communications port on the modem.
4. Turn on the modem and configure your VT emulation package with the following parameters:
When these parameters are set, the startup screen will display. Proceed to
the installation.
Figure 3-22 Connecting to a Modem
RJ45 Modem Port
Modem
Parameter
Mode
Transmit
Bits Parity
Stop Bit
À
Á
RJ45-to-DB25 Modem Adapter
UTP Cable with RJ45 Connectors
Connecting to Console Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Ã
Â
(Figure
3-22), use a UTP cable
Section 3.10
to complete
Ä
RJ45 Console Port
Hardware Installation
3-33