2. Plug the RJ45 connector at the other end of the cable ➀ into the RJ45-to-DB25 female adapter ➂.
3. Connect the RJ45-to-DB25 adapter ➂ to the port labeled COMM on the PC ➃.
4. Turn on the terminal and access the Setup Directory. Set the following parameters on your
terminal:
When these parameters are set, the screen will display. Proceed to
installation.
Figure 3-22 Connecting a VT Series Terminal
Ã
➀
straight-through
UTP
➁
RJ45 console port
3.9.4
Connecting to a Modem
To connect a modem to an Enterasys Networks device modem port
with RJ45 connectors and an optional RJ45-to-DB25 male adapter (PN 9372112), and proceed as
follows:
1. Connect the RJ45 connector at one end of the cable ➀to the RJ45 console port ➁ on the
Enterasys Networks device.
Parameter
Mode
Transmit
Bits Parity
Stop Bit
Â
À
cable with RJ45 connectors
Connecting to Console Port for Local Management
Setting
7 Bit Control
Transmit=9600
8 Bits, No Parity
1 Stop Bit
Section 3.10
1G582-09
➂
RJ45-to-DB25 VT adapter
➃
PC
(Figure
to complete the
PWR
CPU
RESET
COM
1 1
Á
3-23), use a UTP cable
Hardware Installation
3-31