Set Port Mirroring - Enterasys Matrix E1 1G694-13 Configuration Manual

Port Configuration
Port Mirroring Commands
4.2.8.2

set port mirroring

Use this command to designate a single port pair (source and target ports) for mirroring.
set port mirroring port_string port_string {disable | enable}
Syntax Description
port_string
disable | enable
Command Defaults
None.
Command Mode
Read-write.
Examples
This example shows how to enable port mirroring with ge.0.4 as the source port and ge.0.11 as the
target port.
Matrix>set port mirroring ge.0.4 ge.0.11 enable
Port ge.0.4 and port ge.0.11 are enabled for Port Mirroring.
This example shows how to disable port mirroring:
Matrix>set port mirroring disable
Port Mirroring disabled.
4-28 Matrix E1 Series (1G694-13) Configuration Guide
Specifies the port designations for source port and target
port. The first port_string specifies the source on which
the traffic will be monitored. The second port_string
specifies the target port that will duplicate or "mirror" all
the traffic on the monitored port. Since only one port
mirror is allowed per device, it is not necessary to specify
port string when disabling mirroring. For a detailed
description of possible port_string values, refer to
Section 4.1.2.
Disables or enables mirroring on the specified ports.