Table of Contents
Advertisement
Port Configuration
Setting Flow Control
4.2.4.1
show port flowcontrol
Use this command to display the flow control state for one or more ports.
show port flowcontrol [port_string]
Syntax Description
port_string
Command Defaults
If port_string is not specified, flow control statistics for all ports will be displayed.
Command Mode
Read-Only.
Example
This example shows how to display the port flow control state for Gigabit Ethernet front panel
ports 1 through 4. It shows that auto-negotiation is enabled on ports 1 and 4 (therefore, flow
control cannot be enabled on these ports). It also shows that flow control is disabled on port 2, and
enabled on port 3.
Matrix>show port flowcontrol ge.0.15-18
Port ge.0.1 flow control state is auto negotiate.
Port ge.0.2 flow control state is disabled.
Port ge.0.3 flow control state is enabled.
Port ge.0.4 flow control state is auto negotiate.
4-18
Matrix E1 Series (1G694-13) Configuration Guide
(Optional) Specifies the port(s) for which flow control
state will be displayed. For a detailed description of
possible port_string values, refer to
Section
4.1.2.
Advertisement
Table of Contents
