Show Spantree Portcost - Enterasys Matrix E1 1G694-13 Configuration Manual

5.2.2.5

show spantree portcost

Use this command to display cost values assigned to one or more Spanning Tree ports.
show spantree portcost port_string
Syntax Description
port_string
Command Defaults
None.
Command Mode
Read-Only.
Example
This example shows how to display the port cost for front panel port 3. In this case, the 0 value
indicates that the port has been set to use its default value when operating in a Spanning Tree:
Matrix>show spantree portcost ge.0.3
Port cost = 0 for port ge.0.3.
NOTE: This command displays values set using set spantree portcost as described in
Section 5.2.2.6. A value of 0 indicates that the device will use the default STP cost value
assigned to the port when operating in a Spanning Tree. Use the show spantree stats
[port port-string] command as described in
cost values currently in use.
Reviewing and Setting Spanning Tree Port Parameters
Specifies the port(s) for which to display cost values. For a
detailed description of possible port_string values, refer to
Section 4.1.2
.
Section 5.2.1.1
Matrix E1 Series (1G694-13) Configuration Guide
Spanning Tree Configuration
to display the actual port
5-29