Spanning Tree Configuration Command Set; Reviewing And Setting Spanning Tree Bridge Parameters - Enterasys Matrix E1 1G694-13 Configuration Manual

5.2

SPANNING TREE CONFIGURATION COMMAND SET

5.2.1

Reviewing and Setting Spanning Tree Bridge Parameters

Purpose
To display and set Spanning Tree bridge parameters, including device priorities, hello time,
maximum age time, forward delay, path cost, topology change trap suppression, real time message
age and transmit hold count.
Commands
The commands needed to review and set Spanning Tree bridge parameters are listed below and
described in the associated section as shown.
•
show spantree stats
•
set spantree (Section
•
show spantree version
•
set spantree version
•
set spantree priority
•
set spantree hello
•
set spantree maxage
•
set spantree fwddelay
•
show spantree edgeportdelay
•
set spantree edgeportdelay
•
show spantree legacypathcost
•
set spantree legacypathcost
•
show spantree tctrapsuppress
•
set spantree tctrapsuppress
•
show spantree rtmsgage
•
set spantree rtmsgage
•
show spantree txholdcount
•
set spantree txholdcount
(Section 5.2.1.1)
5.2.1.2)
(Section 5.2.1.3)
(Section 5.2.1.4)
(Section 5.2.1.5)
(Section 5.2.1.6)
(Section 5.2.1.7)
(Section 5.2.1.8)
(Section
(Section 5.2.1.10)
(Section
(Section 5.2.1.12)
(Section
(Section 5.2.1.14)
(Section 5.2.1.15)
(Section 5.2.1.16)
(Section 5.2.1.17)
(Section 5.2.1.18)
Reviewing and Setting Spanning Tree Bridge Parameters
5.2.1.9)
5.2.1.11)
5.2.1.13)
Matrix E1 Series (1G694-13) Configuration Guide
Spanning Tree Configuration
5-3