Kolver 032000 Operational Manual page 51

4. Set the first torque level at 20% percentage by pressing
(20% is just an example).
- - - - - - - - S T E P - - 2 - - - - -
p e r c e n t a g e
5. Press OK. You will see:
- - - - - - - - S T E P - - 1 - - - - -
O K
Complete a screwing cycle on the mini k5 and take note of torque value.
In case of error, you will see:
- - - - - - - - S T E P - - 1 - - - - -
E r r . R e p e a t
Just repeat the test.
6. Press ESC to abort the calibration process.
Press OK, then the display will show:
- - - - - - - - S T E P - - 1 - - - - -
E n t e r
Set the torque value by selecting each digit individually pressing
press OK again to save. You will see:
- - - - - - - - S T E P - - 2 - - - - -
p e r c e n t a g e :
7. Set the percentage of the second torque to 25% by pressing
(25% is just an example).
Vers. 211020
E n t e r
S t a r t
c o n f i r m E S C
S t a r t
t o r q u e
0 0 . 0 1 Nm
E n t e r t h e
.
t h e
2 0 %
t e s t
q u i t
t e s t
S c r e w i n g
v a l u e :
and and press OK to confirm it, then
2 5 %
and press OK.
Page 14