Kolver 032000 Operational Manual page 98


CN5 CONNECTOR (25 pin connector - female):
PIN NAME
1 GND
2
3 STOP MOTOR OUT
4 OUTPUT 8
5 OUTPUT 7
6 OUTPUT 6
7 OUTPUT 5
8 OUTPUT 4
9 OUTPUT 3
10 OUTPUT 2
11 OUTPUT 1
12 +24V
13 +5V
14 OK EXT
15 ESC EXT
16 RESET EXT
17 INPUT 8
18 INPUT 7
19 INPUT 6
20 INPUT 5
21 INPUT 4
22 INPUT 3
23 INPUT 2
24 INPUT 1
25 +15V

CN6 CONNECTOR (serial connector 9 pin - male) - FOR BARCODE CONNECTION
PIN NAME
1 +15V
2 RX
5 GND
9 +5V
IMPORTANT: the barcode scanner to be used must have the following features: RS232 transmission with
9600baud, 8 data bits, 1stop bit, no parity, terminators CR-LF.
Vers. 220920
Common to every input. Signals have to be enabled making contact between
the desired signal and this pin (common 0VDC).
Not used
It indicates stop motor is enabled
It indicates you're using program 8
It indicates you're using program 7
It indicates you're using program 6
It indicates you're using program 5
It indicates you're using program 4
It indicates you're using program 3
It indicates you're using program 2
It indicates you're using program 1
+24V available on this pin, they can't be used to charge external devices.
+5V available on this pin, it can't be used to charge external devices
If enabled (see point 4: OK-ESC, in the option menu), remote OK key
function.
If enabled (see point 4: OK-ESC, in the option menu), ESC key function to
reset remote errors.
If enabled (see point 4: OK-ESC, in the option menu), it resets program or
sequence according to the preset function (see point 5: Reset, in the option
menu).
Switch – selection of program 8
Switch – selection of program 7
Switch – selection of program 6
Switch – selection of program 5
Switch – selection of program 4
Switch – selection of program 3
Switch – selection of program 2
Switch – selection of program 1
+15V available on this pin, not used to charge external devices
+15V available on this pin, it can't be used to charge external devices.
Serial reception.
Common to every input. Signals have to be enabled making contact between
the desired signal and this pin (GND)
Not used.
FUNCTION
FUNCTION
21