Table of Contents
Advertisement
ATTENTION: Reaching the torque while the ramp is still on could give as result a different torque level
from the one that results when the ramp is over. This is due to the motor acceleration.
Reaching the torque while the ramp is still on will activate the "screw OK" signal anyway (this option is
useful if you need to tighten screws that are already tightened, the so called "double hit" ).
On the other hand, if you wish to see an error signal during the preset torque in the ramp phase, you can
change the minimum time by setting value which is equal or superior to the ramp value (see point 7).
5) Torque:
you can select the desired torque as a percentage of the torque range of the selected
screwdriver. The torque range is always referred to the MAX speed. In case you're not working at maximum
speed, the torque range will progressively lower in order to avoid motor stalling. If the torque level is
reached correctly, it will be displayed and you will hear a beep sound, too.
Such torque level is indicated as " T: ..% " on the main screen.
6) Tm Fast Spd (Time Fast Speed):
nominal (maximum speed given in the catalogue) and the minimum speed of every single screwdriver (see
table with technical data).
This function is available only if the Fast Speed is active.
- - - - - M E N U - - P R : 1 - - - - -
6 ) T m F a s t
7 ) F a s t
8 ) F i n a l
7) Fast spd (Fast Speed):
(see point 8) before switching to "pre-set speed" (lower speed). The "pre-set speed" is the speed set at point
6. This FAST SPEED time can be set from 0.3 to 10.0 sec.
To disable the function press
pre-set speed (see point 8).
CAUTION: The aim of the FAST SPEED is only to speed up the approach time in case of long screws.
Reaching the torque at higher speed will result in inaccurate torque output. To avoid inaccurate torque
values we suggest first to set a shorter time, and then increase it.
Torque reached during the FAST SPEED won't activate the torque signal and the message "Error FAST
SPEED" will be displayed on the main screen and 2 beep sounds. The red led will turn on, too.
8) Final Spd (Final Speed):
be set between max speed and the pre-set one (see point 7).
- - - - - M E N U - - P R : 1 - - - - -
9 ) R u n t i m e :
1 0 ) M i n
1 1 ) M a x
9) Runtime:
You can set the time of a tightening, from OFF to 20.0 sec. When the pre-set time has been
reached, it results in a torque signal.
The couple reached during this time results in a signal of Correct screw. If the correct screw signal is not
required, set the Minimum time up to a value of 'Minimum Time -0.1sec'.
ATTENTION: Max Time must be set at 20.0 sec.
Vers. 220920
You can select any speed value of the screwdriver between
s p d :
s p d :
It indicates how long the screwdriver should turn at the FAST SPEED speed
until you get to OFF. In this case the screwdriver will automatically start at
You can select the speed of the screwdriver during the FAST SPEED. It can
t i m e :
t i m e :
s p d :
0 . 3 s
o f f
7 0 0 r p m
2 0 . 0 s
o f f F
2 0 . 0 s
5
Advertisement
Table of Contents
