Table of Contents
Advertisement
- - - - O P T I O N - - M E N U - - - -
3 ) P a s s w o r d :
4 ) E S C - O K - R S T :
5 ) U n i t :
3) Password ON:
When YES, you will be asked for the password to enter the menu. Otherwise select NO.
ATTENTION: Password is only asked to enter the menu the first time after switching the unit on.
The default password is: 0000.
4) ESC-OK-RST:
Press ESC in case of error. Press OK at the end of a program or to reset a sequence or a
program (see point 7: Reset).
When INT, the operator must press the required key on the front panel.
When EXT, functions can only be enabled through proper connections on the back panel (see paragraph I/O
connections).
When INT+EXT you can press either he button on the front or on the back panel.
5) Unit:
You can choose between the following units of measurements: Ncm, lbf.in and kgf.cm.
- - - - O P T I O N S - M E N U - - - -
6 ) V e r s i o n s
7 ) S e r i a l
8 ) S e t
6) Versions:
in this screen you can see the versions of boards mounted inside the unit.
7) Serial number:
it is the indication number of the control unit. Default number: 0000000.
It could be the real serial number of the unit or another one you could choose (7 digits max).
This number will also be the name of the folder in the USB drive where you will save the report of your data
(see EDU EXPAND part).
- - - - O P T I O N S - M E N U - - - -
7 ) S e r i a l
8 ) S e t
9 ) C y c l e s :
8) Set time & date:
to set time and date on the control unit.
9) Cycles
- Total number of cycles: It shows the number of tightened and loosened screws. This number
can't be modified.
Vers. 220920
n . 0 0 0 0 0 0 0 0
t i m e
&
d a t e
n . 0 0 0 0 0 0 0 0
t i m e
&
d a t e
0 0 0 0 0 0 0
o n
e x t
N c m
11
Advertisement
Table of Contents
