Kolver 032000 Operational Manual page 148

WARNING: To reduce the risk of injury, before using or servicing tool, read and
understand the following information as well as separately provided safety
instructions (Item number: 0MS000). The features and descriptions of our products
are subject to change without prior notice.
1. Applications
KOLVER electric screwdrivers are used to tighten to the required torque screws,
nuts, studs and any other kind of threaded connection on any material. Obviously,
it is possible to use the screwdrivers with screw having a larger diameter if the
torque fall within the indicated range. All models are reversible and can
consequently be used to unscrew. Electric screwdrivers are mainly used in the
electronic industry as well as for electric appliances, wiring, toys, lamps, glasses, in
the mechanical light industry etc.
2. Use
KOLVER screwdriving system is composed by a screwdriver, a cable with 2 x
M12 female 5 pin connectors and a power supply and control unit. To install it
please follow the instructions.
a) Connect the 5-pin connectors of the cable to the controller and to the
screwdriver and tighten the relevant nuts.
b) Connect the controller plug to a mains supply socket 90 / 230V- 50/60Hz.
c) Switch the controller on through the black button on the back panel.
d) Select the desired setting of speed (A) and slow start (R) options through the
relevant knobs. Please make sure that such settings are compatible with the torque
setting. Since the speed reduction is obtained through a voltage reduction (= power
reduction), if the torque setting is too high for a low speed setting, the clutch may
not operate correctly and get stuck. In such a case, the driver will not run and when
you press the start lever the red light will signal. To reset the driver just turn the bit
chuck until you hear the clutch "click" (usually 180°). Increase the speed setting
before running the driver again.
e) Similarly, the slow start setting should be chosen according to the torque that
must be reached at full speed and not when the slow start is still in action.
g) Do not slide the forward/reverse while the motor is running, it's dangerous for
the motor.
Vers. 080920
EN