Table of Contents
Advertisement
Write USB:
2)
press OK and create your new SETxx.KOL application where you save all the
parameters you have set in the control unit.
O K
Info USB:
3)
press OK and see the loaded program.
You can see the loaded program only if you have saved the program in your USB drive as named as
SETxx.KOL.
TORQUE CALIBRATION
The torque calibration function allows to view the torque value in Nm or in.lbs or kgf.cm directly on the
display of the control unit.
IMPORTANT: You need a torque tester to proceed, either with static transducer (model minik or K)
or with rotary transducer (model minik-e).
CALIBRATION PROCESS:
1. Select Calibration at point 23 of the menu and press OK.
2. The following screen will appear on the display:
- - - - - - - - M E N U - - - - - - - -
2 3 ) C a l i b r a t i o n
3. Press OK to confirm. If you choose OFF, calibration will be interrupted and no torque value will be
displayed. You choose ON, calibration will continue and the following screen will be displayed:
- - - - - - - - S T E P - - 1 - - - - -
p e r c e n t a g e
Vers. 211020
S a v e
S E T 0 0 . K OL
c o n f i r m E S C
L o a d e d
p r o g r a m :
S E T 2 3 . K OL
E n t e r
a s
q u i t
o n
t h e
M I N
Page 13
Advertisement
Table of Contents
