High Speed Interface Configuration Screen (2H23-50R Only) - Cabletron Systems 2H23-50R User Manual

High Speed Interface Configuration Screen (2H23-50R Only)
5.13 HIGH SPEED INTERFACE CONFIGURATION
SCREEN (2H23-50R ONLY)
When the HIGH SPEED CONFIGURATION MENU item is
NOTE
selected for the 2H33-37R, the applicable HSIM Setup screen
displays. Refer to the HSIM user's guide to set operating
parameters for the HSIM installed in the 2H33-37R.
To access the High Speed Interface Configuration menu screen from the
Device Specific Configuration Menu screen, use the arrow keys to
highlight the HIGH SPEED INTERFACE CONFIGURATION menu
item and press ENTER. The High Speed Interface Configuration menu
screen, Figure 5-20, displays.
The High Speed Interface Configuration screen,
NOTE
applies only to slots 5 and 6 of the 2H23-50R. This screen
supports the FE-100TX, FE-100FX, and FE-100F3 Fast
Ethernet Interface Modules that operate at 100 Mbps.
The High Speed Interface Configuration screen displays the types of
interfaces installed in slots 5 and 6, their current operating mode, and
indicates if the ports are linked. This screen also allows the user to enable
or disable Auto-Negotiation and set the Advertised Ability.
2H23-50R/2H33-37R User's Guide
Figure 5-20,
5-47