Changing Source And Destination Ports - Cabletron Systems 2H23-50R User Manual

Chapter 5: Local Management

5.15.2 Changing Source and Destination Ports

Add or delete source port and destination port entries as follows:
1. Use the arrow keys to highlight the Source Port field.
2. Press the SPACE bar or BACKSPACE one or more times to increment
or decrement the port number displayed in the brackets [n] until the
appropriate port number displays.
3. Use the arrow keys to highlight the Destination Port field.
4. Use the SPACE bar or BACKSPACE to step to the appropriate port
number for the destination port.
5. Use the arrow keys to highlight ADD or DEL (delete) in the Status
field.
6. Use the SPACE bar to set Status to either ADD or DEL (delete) and
press ENTER. This adds or deletes the port selections made in steps 2
and 4 and also updates the screen Source Port and Destination Port list.
7. Use the arrow keys to highlight ON or OFF in the Errors field.
8. Use the SPACE bar to set Errors to either ON or OFF and press
ENTER. ON forces the source port to forward errored frames to the
destination port(s). OFF forces the errored frames to be dropped
before forwarding traffic.
If more than one port is to be redirected, repeat steps 1 through
NOTE
8 for each additional setting, then go to step 9 to save all the
new settings at once.
9. Use the arrow keys to highlight SAVE at the bottom of the screen.
Press ENTER. The message "SAVED OK" displays. This saves the
new settings and updates the Source Port and Destination Port
read-only fields.
5-60 2H23-50R/2H33-37R User's Guide