Setting The Mode Switches - Cabletron Systems 2H23-50R User Manual

Appendix C: Optional Installations and Mode Switch Bank Settings
3. Use a Phillips screwdriver to remove the screws attaching the cover to
the chassis. (See
4. Remove the cover by sliding it back until it clears the front of the
chassis and then lifting it straight up and off the chassis.
To reinstall the chassis cover, perform the removal procedures in reverse.
Front
Panel
Note: If the device was rack mounted, the four screws fastening the cover to the
front panel are removed and installed along with the rackmount brackets.
C.2.1

Setting the Mode Switches

Figure C-2 shows the location of the mode switches and the switch
settings for normal operation. These switches are set at the factory and do
not need to be changed.
C-4
Figure C-1.)
Figure C-1 Removing the Chassis Cover
2H23-50R/2H33-37R User's Guide
Chassis
Cover
Cover Screws (7)
Chassis
2286-3