Port Redirect Function Screen - Cabletron Systems 2H23-50R User Manual

5.15

PORT REDIRECT FUNCTION SCREEN

The Port Redirect Function screen can only be used if the
NOTE
operational mode of the device has been set to 802.1D
SWITCHING. Refer to
Mode, for instructions on configuring the device to operate in
this mode.
The Port Redirect Function screen,
each Network, Fast Ethernet, or HSIM port as a source or destination
port. A port can be set to have one or more destination ports. For example,
port 1 can be set as a source port with three destinations, ports 2, 3, and 4.
Traffic from port 1 is then automatically redirected to ports 2, 3, and 4.
Port 1 can also serve as a destination port for other ports.
the port organization.
2H23-50R
CONN 1 = Network Port 1, 10 Mbps
Network Port 2, 100 Mbps
CONN 2 = Network Port 3, 10 Mbps
Network Port 4, 100 Mbps
CONN 3 = Network Port 5, 10 Mbps
Network Port 6, 100 Mbps
CONN 4 = Network Port 7, 10 Mbps
Network Port 8, 100 Mbps
Fast Ethernet Slot 5 = Port 9
Fast Ethernet Slot 6 = Port 10
The port redirect function is extremely useful for troubleshooting
purposes, as it allows traffic to be sent to a particular port(s) where, with
the use of an analyzer or RMON probe, all current traffic from the source
port(s) can be examined.
Although all traffic from the source port (including, if desired,
NOTE
errored frames) is sent to the destination port, normal switching
is still performed for all frames on the source port.
2H23-50R/2H33-37R User's Guide
Section
Table 5-6 CONN/Port Organization
Port Redirect Function Screen
5.7.9, Setting the Operational
Figure 5-22, enables the user to set
2H33-37R
CONN 1 = Network Port 1, 10 Mbps
Network Port 2, 100 Mbps
CONN 2 = Network Port 3, 10 Mbps
Network Port 4, 100 Mbps
CONN 3 = Network Port 5, 10 Mbps
Network Port 6, 100 Mbps
HSIM = Port 7
Table 5-6 shows
5-57