Repeater Port Configuration Screen - Cabletron Systems 2H23-50R User Manual

Chapter 5: Local Management
The following introduces each screen that is accessible from the Repeater
Configuration Menu.
REPEATER PORT CONFIGURATION
Used to monitor the link status and current operating mode of each port
on the 10-Mbps or 100-Mbps network of a front panel connector, and also
turn each port on or off. For details, refer to
DEVICE LEVEL SECURITY CONFIGURATION
Used to set the state of security for each port of a connector. All ports on a
connector can be set to receive all frames (NonSecure state), lock on the
source address of the next frame received (LockOnNext), or lock on the
address of the last frame received (LockedOnAddr). For details, refer to
Section 5.20.
PORT LEVEL SECURITY CONFIGURATION
Used to set the security for all ports of a connector. For details, refer to
Section 5.21.
5.19

REPEATER PORT CONFIGURATION SCREEN

The Repeater Port Configuration screen,
the link status and current operating mode of each port on a 10-Mbps or
100-Mbps network of a front panel connector. The screen is also used to
change the operating mode, and turn each port on (enable) or off
(disable).
To access the Repeater Port Configuration screen, use the arrow keys to
highlight the REPEATER PORT CONFIGURATION menu item from
the Repeater Configuration Menu screen and press ENTER. The Repeater
Port Configuration screen displays.
5-66
Section 5.19.
Figure 5-26, is used to monitor
2H23-50R/2H33-37R User's Guide