High Speed Interface Configuration Screen - Cabletron Systems 2E43-51 User Manual

Chapter 5: Local Management
5.14 HIGH SPEED INTERFACE CONFIGURATION
SCREEN
The High Speed Interface Configuration screen,
NOTE
applies only to ports 5 and 6. This screen supports the
FE-100TX, FE-100FX, and FE-100F3 Fast Ethernet Interface
Modules that operate at 100 Mbps.
The High Speed Interface Configuration screen displays the types of
interfaces installed in ports 5 and 6, their current operating mode, and
indicates if the ports are linked. This screen also allows the user to enable
or disable Auto-Negotiation and set the Advertised Ability.
To access the High Speed Interface Configuration screen from the High
Speed Interface Configuration Menu screen, use the arrow keys to
highlight the FAST ETHERNET INTERFACES menu item and press
ENTER. The High Speed Interface Configuration screen displays.
Event Message Line
Device Name: 2E43-51
Port Type
Link Status
Current Oper. Mode
Desired Oper. Mode
Advertised Ability
SAVE
Figure 5-21 High Speed Interface Configuration Screen
5-46
2E43-51 LOCAL MANAGEMENT
High Speed Interface Configuration
Port 5
FE-100TX
Link
100Base-TXFD
[Auto-Negotiation]
[100Base-TXFD] [Disabled]
EXIT
2E43-51/2E43-51R User's Guide
Figure
Firmware Revision: XX.XX.XX
BOOTPROM Revision: XX.XX.XX
Port 6
Unknown
N/A
[N/A]
[N/A]
[N/A]
RETURN
5-21,
2251-24