Setting The Port Level Security - Cabletron Systems 2H23-50R User Manual

Chapter 5: Local Management
Address (Modifiable)
Enables the user to enter an address to which the security function is
applied. When the port detects any other address in a frame, the switch
executes the action selected in the Action On Intruder field. When the
security state setting is NonSecure, the field displays the source address of
the last frame.
CONNECTOR # (Selectable)
This command field selects the front panel connector to which the port
security settings will be applied.

5.21.1 Setting the Port Level Security

To set the security for each repeater port on a connector, proceed as
follows:
1. Use the arrow keys to highlight the CONNECTOR # field.
2. Use the SPACE bar to step to the appropriate connector number.
3. Use the arrow keys to highlight the SECURITY STATE field for a
connector.
4. Use the SPACE bar to step to the appropriate security level.
5. If the security level chosen causes the DisablePort and SendTrap
fields to display under Action On Intruder, use the arrow keys to
highlight the DisablePort field. If the security level chosen does not
cause the fields to display under Action On Intruder, proceed to step 9.
6. To change the DisablePort setting to NoDisable, press the SPACE
bar to toggle the setting.
7. Use the arrow keys to highlight the SendTrap field.
8. To change the setting to NoTrap, press the SPACE bar to toggle the
setting.
9. If the security state selected is LockedOnAddr, use the arrow keys to
highlight the Address field for the port. Otherwise go to step 11.
10. Enter the address to lock on.
5-78 2H23-50R/2H33-37R User's Guide