Cabletron Systems 2H23-50R User Manual page 147

There are two categories of commands in the command set.
• Built-in Commands – Allow the user to access and manage network
devices. The commands are arp, bridge, defroute, netstat, ping,
reset, show, traceroute, soft-reset, telnet, link_trap, and
atm_stp_state.
• Special Commands – Allow the user to exit from Network Tools. The
commands are done, exit, and quit.
The conventions used in describing the commands in Network
NOTES
Tools are as follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by
the user is shown in bold Helvetica font
To abort the output or interrupt a process, press the CONTROL
key and c key simultaneously, designated as ^C here.
The commands are presented in the following format:
command:
Syntax:
Description:
Options:
Example:
2H23-50R/2H33-37R User's Guide
Shows the required command format. It
indicates where arguments, if any, must be
specified.
Briefly describes the command and its uses.
Lists any additional fields in the appropriate
format which may be added to the command.
Shows an example of the command.
Network Tools
.
5-97