Programming Devices - Omron CS1W-CLK12-V1 Operation Manual

Specifications and Configurations
1-2-7

Programming Devices

Programming Device for the PLC
22
b) Ensure that the cable does not exceed its maximum bending radius.
c) The optical fiber cable's optical characteristics and connector are the
same as those for standard connecting cables.
2. Connect Controller Link Units (CS1W-CLK52-V1) used in duplex operation
with a standard GI cable. (Use a cable no longer than the maximum allow-
able distance between standard nodes.)
A Programming Device for the PLC, the Controller Link Support Software, or
CX-Programmer are needed to use a Controller Link Network.
One of the following Programming Devices is necessary when using the auto-
matically setting data links or the message service.
Programming
Console
IBM PC/AT or
compatible
The following operations are possible.
• Selecting manual or automatic setting for data links.
• Setting the data link mode to "automatic" (software switch setting).
• Starting/stopping data links (Start Bit: ON/OFF)
• Programming for the message service.
• Reading (monitoring) the network status.
Programming
Device
CX-Programmer
(for PLC)
Programming Con-
sole
Note 1. Use CX-Programmer Ver. 3.0 or later to make settings for Duplex Commu-
nications Units in CS1D Systems.
2. For details of CX-Programmer, refer to the CX-Programmer Operation
Manual.
Start-up node
or
+
CX-Programmer
Software switches (DM Area)
External Model number
appearance
WS02-CXP@@-EV3
(Ver 3.@)
CQM1-PRO01-E
C200H-PRO27-E
CVM1-PRS21-EV1
Section 1-2
CPU Unit
Controller Link
Applicable PLCs
CS-series, C200HX/
HG/HE, CVM1-series,
and CQM1H-series
PLCs
C200HX/HG/HE,
C200H/C200HS,
CQM1, and CQM1H-
series PLCs
CVM1 and CV-series
PLCs