Devices Required For Connection - Omron CS1W-CLK12-V1 Operation Manual

Specifications and Configurations
1-2-6

Devices Required for Connection

Communications Cables
Optical Bus or Optical
Ring System (H-PCF
Cable)
To set up a Controller Link Network the following devices are needed in addi-
tion to a Controller Link Unit and a PLC.
The following devices are required for the Optical Bus or Optical Ring (H-PCF)
Controller Link Network. The cable and connectors are the same as those
used for Optical SYSMAC LINK Networks.
Optical Fiber Cables (Indoor Use Only)
Use the following Optical Fiber Cables (Hard Plastic-clad Fiber: H-PCF).
Name
H-PCF cables
Note The Optical Fiber Cable model numbers are as follows.
S3200-H@@@@@@@
Name
Connector
Inline Adapter S3200-COIAT2000
Note 1. Either full-lock or half-lock connectors can be used in a Controller Link Net-
work, but we recommend full-lock connectors to prevent accidental discon-
nections during operation.
2. The maximum distance between nodes is slightly shorter for connectors
with crimp-cut cables compared to connectors assembled with adhesive.
Specifications
Black
Orange
Tensioner option
None: Standard (with tension member)
N:
Cable length
@@@
A B
(A/10) x 10
Cable color
B: Black
O: Orange
Cable specification
L: With power supply line
C: Without power supply line
Type
B: Cord
C: Cable
Model
S3200-COCF2011 Use to connect a cable to a node.
(Full-lock connector for crimp-cut cable.)
S3200-COCF2511 Use to connect a cable to a node.
(Half-lock connector for crimp-cut cable.)
Use to connect or extend cables.
(Use one adapter for each connection.)
10 m S3200-HCCB101
50 m S3200-HCCB501
100 m S3200-HCCB102
500 m S3200-HCCB502
1,000 m S3200-HCCB103
10 m S3200-HCCO101
50 m S3200-HCCO501
100 m S3200-HCCO102
500 m S3200-HCCO502
1,000 m S3200-HCCO103
Without tension member
B m
Specifications
Section 1-2
Model
19