Send/Receive Data Areas - Omron CS1W-CLK12-V1 Operation Manual

Introduction
6-1-3

Send/Receive Data Areas

CS-series PLCs
Note
118
Type of command
Error data
File Memory
Forced set/reset
For details on commands for CS-series PLCs, refer to the CS-series Program-
mable Controllers Programming Manual (W340). For details on commands for
CVM1 and CV-series PLCs, refer to the FINS Commands Reference Manual
(W227).
The data areas that can be used as operands in the SEND and RECV instruc-
tions depend on the PLC, as shown in the following tables. Be sure to set the
operands so that the end of the data area is not exceeded.
Area
CIO (IR etc.)
Work Area (WR)
Holding Area
Auxiliary Area
Timer
Counter
Data Memory
Extended Data Memory
1. Writing is not possible to words A000 through A447 in the Auxiliary Area.
2. A maximum of thirteen banks can be used for Expansion DM. For details
on extended data memory and the number of banks, refer to the operation
manual for the PLC model that is being used.
ERROR CLEAR
ERROR LOG READ
ERROR LOG CLEAR
FILE NAME READ
SINGLE FILE READ
SINGLE FILE WRITE
MEMORY CARD FOR-
MAT
FILE DELETE
VOLUME LABEL CRE-
ATE/DELETE
FILE COPY
FILE NAME CHANGE
FILE DATA CHECK
MEMORY AREA FILE
TRANSFER
PARAMETER AREA
FILE TRANSFER
PROGRAM AREA FILE
TRANSFER
FORCED SET/RESET
FORCED SET/RESET
CANCEL
CIO 0000 to CIO 6143
W000 to W511
H000 to H511
A000 to A959 (See note 1.)
TIM0000 to TIM4095
CNT0000 to CNT4095
D00000 to D32767
E00000 to E32767 (See note 2.)
Section 6-1
Code CS CVM1/
CV
2101 Yes Yes
2102 Yes Yes
2103 Yes Yes
2201 Yes Yes
2202 Yes Yes
2203 Yes Yes
2204 Yes Yes
2205 Yes Yes
2206 No Yes
2207 Yes Yes
2208 Yes Yes
2209 No Yes
220A Yes Yes
220B Yes Yes
220C Yes Yes
2301 Yes Yes
2302 Yes Yes
Range