Omron CS1W-CLK12-V1 Operation Manual page 244

Error Log
Error Contents
code
0003 PLC shared RAM error
Hex
0004 CPU Bus Unit ID number error
Hex
0005 Unit number error
Hex
0006 CPU Unit error
Hex
000E I/O Bus error
Hex
000F PLC initialization error
Hex
0010 PLC Setup exceeds capacity
Hex
0011 PLC initialization error
Hex (Time out)
0012 CPU Unit memory error
Hex
0013 CPU Unit write-protected
Hex
Detail code
1st byte 2nd byte
01 Hex: 00 Hex
Cyclic
02 Hex:
Event
04 Hex:
CPU bus link
00 Hex 00 Hex
Unit set The value
value recognized
by the CPU
Unit
Bit 11: No relevant Unit in
I/O table.
Bit 12: Hardware test unit
number recog-
nized.
Bit 13: Incorrect unit num-
ber.
Bit 14: Duplicated unit
number.
00 Hex fixed 00 Hex fixed Check the operating
01 Hex:
01 Hex:
Read error Data link
02 Hex: table
Write error 02 Hex: Net-
work param-
eters
03 Hex:
Routing
table
04 Hex: PLC
Setup Area
Correction Written to
EEPROM
Check operating Yes
environment.
Check I/O Connect- Yes
ing Cables.
Check the Unit num- Yes
ber setting. Recre-
ate the I/O table.
Check the Unit num- Yes
ber settings. Recre-
ate the I/O table.
Yes
environment.
Check the operating Yes
environment.
Reduce the number Yes
of CPU Bus Units
mounted on each
CPU Unit by one.
Check the operating Yes
environment.
Reset the appropri- Yes
ate data.
Release the CPU Yes
Unit write protect.
Section 10-3
Applicable
PLC
CV
CV, CS
CV
CV, CS
CS
CS
CS
CS
CS
CS
227