Remote Programming And Monitoring - Omron SYSMAC LINK C1000H-SLK21-V1 System Manual

Remote Programming and Monitoring

7-1

Remote Programming and Monitoring

Peripheral Device
Connection
Remote Communications
Limits
112
Any C200HX, C200HG, C200HE, C200HS, C200H, C1000H, or C2000H
(simplex) PC on a SYSMAC LINK Network can be remotely programmed and
monitored using a SSS/CVSS connected to any other PC on the network.
C2000H Duplex PCs cannot be remotely programmed and monitored
through the SYSMAC LINK Network. Remote programming or monitoring of
the CVM1 and CV-series PCs is not possible.
The SSS is connected to C-series PCs via a C500-IP004 or C200H-IP006/007
Peripheral Interface Unit and can provide remote programming and monitoring
capability for PCs in the same Network. In addition, the CVSS (CV Support Soft-
ware, see note following diagram) running on an IBM-PC/AT or compatible can
be used. The abbreviations in the diagram below indicate the following OMRON
products:
SLK: SYSMAC LINK Unit
NSB: SYSMAC LINK Network Service Board
IP: Peripheral Interface Unit or Conversion Cable
PC
SLK
SLK
IP PC
SSS
Note When the C- and CV-series PCs are in the same system configuration, CVSS on
an IBM-PC/AT or compatible can be used.
The SSS can provide remote programming and monitoring capability for all PCs
in the same Network. If the SSS is connected to a PC that is part of two Networks,
i.e., one that has two SYSMAC LINK Units mounted to it, then remote program-
ming and monitoring are possible for any PC in either Network.
PC PC
SLK SLK
NSB
Computer
Section 7-1