Omron CS1W-CLK12-V1 Operation Manual page 143

Using the Message Service
(Continued from the previous page)
Execution
condition
000001 A20207
120000
(See note 1.)
120003
120002
(See note 1.)
120002 A20207
Network Instruction Error Flag
120002 A21907
120002 120003 A21907
Note
126
S
@MOV(21)
@MOV(21)
@MOV(21)
@MOV(21)
@MOV(21)
@RECV(98)
DIFU(13) 120003
@XFER(70)
1. With CS-series PLCs, the Network Instruction Enabled Flag in A20200 to
A20207 corresponding to communications ports will be OFF even when
PMCR (PROTOCOL MACRO) is being executed.
2. When using the sample program, make sure that the bits and words used
in the sample program are not the same as those in the user program or
by Special I/O Units.
The reception program will run when CIO 00001
turns ON, provided that the Network Instruction En-
KEEP
abled Flag is ON and the SEND instruction has not
120002
been executed.
CIO 120002 remains ON while the RECV instruction
R
is being executed, and it turns OFF when instruction
execution has been completed.
Control Data Preparation
#0010
Word Content
D00005
D00005 0 0
D00006 0 0
#0003
D00007 2 0
D00006
#2000
D00008 0 7
D00007
D00009 0 0
#0705
D00008
#0000
D00009
Transfers the 16 words beginning at A100 of net
work address 3, node address 32, and Unit address
A100
0 (PLC) to 2000.
2000
D00005
Creates reset input.
Turns ON to indicate reception error.
121001
Transmitted data (16 words from 2000) moved into
words beginning at D00040 for storage.
#0016
2000
D00040
Section 6-3
Meaning
1 0 16 receive words
0 3 Destination network
address = 3
0 0 Remote node
address = 32
Destination Unit
address = 0
0 5 Response required
Port No. 7 used
No. of resends = 5
0 0 Response monitoring
time = Default